The following information is required for a new offset.

Name. See: Common Parameters.

This should be the name of the mast that the offset defines the attachment relationship for.

This name will never be shown in Lineardraft, and is only used for Zebraware engineers.

Description. See: Common Parameters.

Additional information on the mast or offset.

This information will never be shown in Lineardraft, and is only used for Zebraware engineers.

Order Index. See: Common Parameters.

The order index for an offset will be the order that the offsets appear for each gantry in drop-down menus for Zebraware engineers.

Offset ValueY. This parameter is the distance along the track between the centre of the mast and the centre of the gantry.

A positive value of Offset ValueY will place the gantry in the direction of increasing chainage.

A negative value of Offset ValueY will place the gantry in the direction of decreasing chainage.

Offset ValueZ. This parameter is the vertical distance between the top of the mast and the bottom of the gantry.

If the gantry item has the ‘Is Height Independent’ parameter as ‘True’, then this parameter must be 0.

A positive value of Offset ValueZ will place the bottom of the gantry above the top of the mast.

A negative value of Offset ValueZ will place the bottom of the gantry below the top of the mast.

Template Type. See: Common Parameters.

This parameter must be ‘Fixed’ for offsets.